Polymer Systems
Technology Limited

Advanced Engineering

Defence:
Commercial Aviation:
Optoelectronics:
Electronics:

FS-3781

High Consistency Rubbers,Molding Elastomer

Fluorosilicone High Consistency Elastomer

DESCRIPTION
  • Pre-catalyzed, high consistency elastomer (HCR)
  • Strained through a 400-mesh screen (minimum) to ensure freedom from particulate contamination
APPLICATION
  • Applications requiring solvent resistance
  • Transfer and compression molding parts such as: o-rings, gaskets, stoppers and seals
  • Calendering and extruding
PROPERTIES
Typical PropertiesAverage Result
Uncured:
AppearanceTranslucent
Plasticity110 mils (2.8 mm)
Cured: 30 minutes at 120°C (248°F), then post-cured 1 hour at 150°C (302°F)
Specific Gravity1.33
Durometer, Type A30
Tensile Strength850 psi (5.9 MPa)
Elongation300%
Tear Strength40 ppi (7.1 kN/m)
Percent Swell (166 hours in JP8 at 60°C (140°F))15%

Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.

Packaging

5 Pound (2.27 kg)
10 Pound (4.54 kg)

Warranty

12 Months

Product Profile - Full Details Product Profile
Material Safety Data Sheet EU EN Material Safety Data Sheet

Biomaterials

Medical Silicones
Biomaterials - Medical Silicones for Healthcare

Advanced Technologies

Advanced Technologies Industrial & Engineering Silicones
Space - Aviation Grade Industrial & Engineering Silicones

Tubing

Food Medical Industrial Grade Silicone Tubing
Food, Medical & Industrial Quality Silicone Tubing

Equipment

Silicone Mixing Dispensing Degassing Equipment
Mixing Dispensing & Degassing Equipment for Silicone