Offers a high tear strength, good physical properties
10:1 Mix Ratio (Part A:B)
Meets or exceeds the ASTM E 595 low outgas specifications outlined in NASA SP-R-0022A and European Space Agency PSS-014-702, with a TML of ≤1% and CVCM of ≤0.1%
APPLICATION
For applications requiring low outgassing and minimal volatile condensables under extreme operating conditions
To provide protection of electric components and assemblies against shock, vibration, moisture, dust, chemicals and other environmental hazards
Ideal for use in potting connectors, cable harness breakouts, molded high-voltage terminals, seals and gaskets due to a high tear strength
PROPERTIES
Typical Properties
Average Result
Uncured:
Appearance
Translucent
Viscosity, Part A
90,000 cP (90,000 mPas)
Work Time
3 hours
Tack-Free Time
15 hours
Cured: 15 minutes at 150°C (302°F)
Specific Gravity
1.1
Durometer, Type A
35
Tensile Strength
925 psi (6.4 MPa)
Elongation
400%
Tear Strength
75 ppi (13.2 kN/m)
Collected Volatile Condensable Material (CVCM)
0.04%
Total Mass Loss (TML)
0.26%
Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Product Profile
