Typical Properties | Average Result |
Uncured: | |
Appearance* | Black |
Viscosity* | 300,000 cP (300,000 mPas) |
Extrusion Rate* (Performed using 14 gauge 1.5 inch metal tipand 30 psi air pressure) | 0.9 g/min |
Cured: 15 minutes at 200°C (392°F) | |
Specific Gravity* | 1.15 |
Durometer, Type A* | 20 |
Tensile Strength* | 750 psi (5.2 MPa) |
Elongation* | 700% |
Tear Strength* | 50 ppi (8.8 kN/m) |
Rheometer (ODR) Maximum Torque* | 30 in-lbs |
Rheometer (ODR) Scorch Time* | 2.5 minutes |
Collected Volatile Condensable Material (CVCM)* | 0.05% |
Total Mass Loss (TML)* | 0.48% |
Volume Resistivity | 1 x 1015 ohm cm |
Dielectric Constant at 100Hz | 3.1 |
Dissipation Factor at 100 Hz | 0.001 |
*Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Recommended Primer CF1-135
Note: Some bonding applications may require the use of a primer.
Packaging
3 cc Syringe
30 cc Syringe
3 oz Tube (89 mL)
6 oz Tube (177 mL)
Warranty
6 Months