Typical Properties | Average Result |
Uncured: | |
Appearance* | Tan |
Work Time* | 2.75 hours |
Cured: 30 minutes at 150°C (302°F) | |
Specific Gravity* | 3.39 |
Durometer, Type A* | 85 |
Tensile Strength* | 525 psi (3.6 MPa) |
Volume Resistivity* | 0.005 ohm cm |
Thermal Conductivity | 1.20 W/(mK)(29 x 10-4 cal/(cm sec°C)) |
Moisture Absorption, % gain after 168 hours at 85°C, 85% R.H. | 0.16% |
Coefficient of Linear Thermal Expansion | |
Below Tg (-100°C to -50°C) | 140 ppm/°C (140 µm/m/°C) |
Above Tg (-30°C to 250°C) | 215 ppm/°C (215 µm/m/°C) |
Dynamic Mechanical Analysis (DMA) | See Attached Graph |
Collected Volatile Condensable Material (CVCM)* | 0.01% |
Total Mass Loss (TML)* | 0.02% |
*Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Recommended Primer CF1-135
Note: Some bonding applications may require the use of a primer.
Packaging
50 Gram Kit
100 Gram Kit
250 Gram Kit
500 Gram Kit
Warranty
12 Months