Two-part, controlled volatility, clear silicone gel
1:1 Mix Ratio (Part A: Part B)
APPLICATION
For applications requiring low outgassing and minimal volatile condensables under extreme operating conditions to avoid condensation in sensitive devices
Useful for potting intricate assemblies due to a low viscosity
As an embedding or potting compound for environmental protection of electronic assemblies and components in electronic or space applications
PROPERTIES
Typical Properties
Average Result
Uncured:
Appearance
Transparent
Viscosity,tested within 15 minutes after catalzyation
2,500 cP (2,500 mPas)
Work Time
>30 hours
Cured: 30 minutes at 150°C (302°F)
Penetration (GCA Penetrometer, 19.5 g shaft, 6.35 mm diameter, 5 seconds)
4 mm
Collected Volatile Condensable Material (CVCM)
0.04%
Total Mass Loss (TML)
0.16%
Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Product Profile
