Uncatalyzed, vinyl-functional, high consistency silicone elastomer
Low durometer
Requires the addition of a peroxide catalyst to accomplish vulcanization
Strained through a 400-mesh screen (minimum)
APPLICATION
For a wide variety of fabrication techniques for the healthcare industry including: molding, calendering and extruding
PROPERTIES
Typical Properties
Average Result
Uncured:
Appearance
Translucent
Plasticity
70 mils (1.8 mm)
Cured: 5 minutes at 116°C (241°F). Catalyzed with 1 pph of CAT-1
Specific Gravity
1.10
Post Cured: 2 hours at 177°C (351°F). Stabilize for 3 hours minimu
Durometer, Type A
35
Tensile Strength
1,350 psi ( 9.3 MPa)
Elongation
800%
Tear Strength
130 ppi (22.9 kN/m)
Stress at 200% Strain
190 psi (1.3 MPa)
Tissue Culture (Cytotoxicity Testing)
Pass
Elemental Analysis of Trace Metals
Pass
These properties tested on a lot-to-lot basis. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Packaging
1 Pound (450 g)
5 Pound (2.27 kg)
25 Pound (11.38 kg)
Warranty
12 Months
Product Profile
Material Saftey Data Sheet EU EN
Example packaging
For Use With High Consistency Materials:
VersaSil³
Medical Silicones
Hand Operated Roll Mill
Hand Operated Roll Mill PST-HR
Basic Desk-top Roll Mill
Basic Small Electric Roll Mill PSTEBR0
Standard & Pro Roll Mill
Standard PSTEBR1
Pro PSTEBR2
Standard & Pro Bench Top
Full Access Bench Top Roll Mills PST-EBR-3 PST-EBR-4
Product Profile
