Life Science

Implant Line

MED-4725

Platinum Cure

High Consistency Silicone Elastomer

DESCRIPTION
  • Two-part, low tension set silicone elastomer
  • Cures with heat via addition-cure chemistry
  • Has a non-tacky surface and no volatile by-products or peroxide residues
  • Strained through a 400-mesh screen (minimum)
  • 1:1 Mix Ratio (Part A: Part B)
APPLICATION
  • For a wide variety of fabrication techniques for the healthcare industry including: molding, calendering and extruding
PROPERTIES
Typical PropertiesAverage Result
Uncured:
AppearanceTranslucent
Plasticity, Part A85 mils (2.2 mm)
Plasticity, Part B80 mils (2.0 mm)
Work Time2.0 hours
Cured: 10 minutes at 171°C (340°F). Stabilize for 24 hours minimum at ambient temperature and humidity.
Specific Gravity1.11
Durometer, Type A30
Tensile Strength1,395 psi (9.6 MPa)
Elongation890%
Tear Strength135 ppi (23.8 kN/m)
Stress at 200% Strain110 psi (0.76 MPa)
Tissue Culture (Cytotoxicity Testing)Pass
Elemental Analysis of Trace MetalsPass

These properties tested on a lot-to-lot basis. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.

Packaging

2 Pound Kit (900 g)
10 Pound Kit (4.54 kg)
50 Pound Kit (22.68 kg)

Warranty

12 Months

Product Profile - Full Details Product Profile
Material Saftey Data Sheet EU EN Material Saftey Data Sheet
Example packaging
Example packaging

Biomaterials

Medical Silicones
Biomaterials - Medical Silicones for Healthcare

Advanced Technologies

Advanced Technologies Industrial & Engineering Silicones
Space - Aviation Grade Industrial & Engineering Silicones

Tubing

Food Medical Industrial Grade Silicone Tubing
Food, Medical & Industrial Quality Silicone Tubing

Equipment

Silicone Mixing Dispensing Degassing Equipment
Mixing Dispensing & Degassing Equipment for Silicone