Flowable, two-part, optically clear, high durometer silicone
1:1 Mix Ratio (Part A: Part B)
APPLICATION
Use for potting and encapsulating electronic devices and for making molded parts
Useful in any application requiring a flowable, high durometer material that cures at lower temperatures for heat sensitive parts.
PROPERTIES
Typical Properties
Average Result
Uncured:
Appearance
Transparent
Viscosity, Part A
30,000 cP (30,000 mPas)
Viscosity, Part B
20,000 cP (20,000 mPas)
Work Time
2 hours
Cured: 2 hours at 50°C (122°F)
Specific Gravity
1.07
Durometer, Type A
75
Tensile Strength
1,200 psi (8.3 MPa)
Elongation
65%
Tear Strength
35 ppi (6.2 kN/m)
Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Product Profile
