Typical Properties | Average Result |
Uncured: | |
Appearance* | Rust Red |
Viscosity, Base* | 55,000 cP (55,000 mPas) |
Work Time* | 3 hours |
Cured: 7 days minimum at ambient temp. and humidity | |
Appearance* | Elastomeric Solid |
Specific Gravity* | 1.49 |
Durometer, Type A* | 55 |
Tensile Strength* | 950 psi (6.6 MPa) |
Elongation* | 150% |
Tear Strength* | 40 ppi (7.1 kN/m) |
Lap Shear Strength* (primed w/ SP-120) | 500 psi (3.4 MPa) |
Dielectric Strength | 825 VOLTS/MIL (32.5 KV/MM) |
Coefficient of Linear Thermal Expansion | |
Below Tg (-150°C to -115°C) | 60 ppm/°C (60µm/m/°C) |
Above Tg (-95°C to 250°C) | 330 ppm/°C (330µm/m/°C) |
Dynamic Mechanical Analysis (DMA) | See Attached Graph |
Collected Volatile Condensable Material (CVCM)* | 0.03% |
Total Mass Loss (TML)* | 0.55% |
Thermal Conductivity | 0.27 W/(m K)(6.48 cal/(cm sec°C)) |
*Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Recommended Primer SP-120
Note: Some bonding applications may require the use of a primer.
Packaging
50 Gram Kit
100 Gram Kit
250 Gram Kit
500 Gram Kit
Warranty
6 Months