Typical Properties | Average Result |
Uncured: | |
Appearance, Part A | Black |
Appearance, Part B | Clear |
Extrusion Rate, tested 25 minutes after catalyzation† | 300 g/min |
Extrusion Rate, tested 4 hours after catalyzation† | 150 g/min |
Cured: 2 hours at 65°C (149°F) | |
Appearance | Black, elastomer |
Specific Gravity | 1.07 |
Durometer, Type A | 40 |
Tensile Strength | 525 psi (3.6 MPa) |
Elongation | 225% |
Volume Resistivity | 25 ohm cm |
Collected Volatile Condensable Material (CVCM) | 0.03% |
Total Mass Loss (TML) | 0.27% |
Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
†(Performed using a SEMCO® 440 nozzle with a 1/8" orifice and 90± 5 psi air pressure)
Recommended Primer SP-120
Note: Some bonding applications may require the use of a primer.
Packaging
100 Gram Kit
250 Gram Kit
500 Gram Kit
Warranty
12 Months