Typical Properties | Average Result |
Uncured: | |
Appearance* | Green-gray paste |
Flow, Base* (0.375" plunge for 30 seconds, mix vigorously for 5 minutes prior to testing) | 4 inches (10.2 cm) |
Work Time* | 2 hours |
Cured: 7 days minimum at ambient temp. and humidity | |
Specific Gravity* | 3.23 |
Durometer, Type A* | 75 |
Tensile Strength* | 300 psi (2.1 MPa) |
Elongation* | 70% |
Tear Strength* | 55 ppi (9.7 kN/m) |
Lap Shear Strength*(primed w/ SP-120) | 185 psi (1.3 MPa) |
Volume Resistivity at 200±5°C* | 0.003 ohm cm |
Thermal Conductivity | 1.50 W/(mK)(36 x 10-4 cal/(cm sec°C)) |
Collected Volatile Condensable Material (CVCM)* | 0.02% |
Total Mass Loss (TML)* | 0.31% |
*Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Recommended Primer SP-120
Note: Some bonding applications may require the use of a primer.
Packaging
50 Gram Kit
100 Gram Kit
250 Gram Kit
500 Gram Kit
Warranty
12 Months