Two-part, translucent silicone system designed for use with injection molding equipment
Cures with heat via addition-cure chemistry
1:1 Mix Ratio (Part A: Part B)
APPLICATION
For the injection molding of parts requiring a material with a low durometer including: molded rubber stoppers, gaskets, seals, valves, o-rings and other precision parts
Suitable for over-molding applications
Can be used with NuSil's Healthcare color masterbatches for applications requiring colored silicones
PROPERTIES
Typical Properties
Average Result
Uncured:
Appearance
Translucent
Extrusion Rate†, Part A
60 g/min
Extrusion Rate†, Part B
90 g/min
Work Time
72 hours
Cured: 5 minutes at 150°C (302°F). Stabilize for 3 hours minimum at ambient temperature and humidity.
Specific Gravity
1.14
Durometer, Type A
20
Tensile Strength
910 psi (6.3 MPa)
Elongation
875%
Tear Strength
125 ppi (22.0 kN/m)
Tissue Culture (Cytotoxicity Testing)
Pass
Elemental Analysis of Trace Metals
Pass
These properties tested on a lot-to-lot basis. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
†(Performed using a SEMCO® model 250-A pneumatic gun with a ⅛ nozzle orifice and 90± 5 psi air pressure)
Packaging
50 mL Side-by-Side Kit
2 Pint Kit (910 g)
2 Gallon Kit (7.28 kg)
Product Profile
