Polymer Systems
Technology Limited
Life Science
Implant Line
MED-6400
Dispersions
Addition Cure Silicone Dispersion
DESCRIPTION
- Two-part, low viscosity, heat curable silicone dispersion
- Cures via addition-cure chemistry
- 1:1 Mix Ratio (Part A: Part B)
APPLICATION
- Suitable for dip casting and heat-curing of thin elastomeric films
- Low viscosity makes dispersions ideal for use as sprayable coatings
Important document: 
PDF Guide to Silicone Dispersions
| Typical Properties | Average Result |
| Uncured: | |
| Appearance | Translucent |
| Non-Volatile Content | 35% |
| Viscosity | 860 cP (860 mPas) |
| Cured: 30 minutes at 25°C (77°F), 45 minutes at 75°C (167°F), and 135 minutes at 150°C (302°F) | |
| Durometer, Type A | 30 |
| Refractive Index | 1.43 |
| Tensile Strength | 1,600 psi (11.3 MPa) |
| Elongation | 850% |
| Tear Strength | 160 ppi (28.2 kN/m) |
| Tissue Culture (Cytotoxicity Testing) | Pass |
| Elemental Analysis of Trace Metals | Pass |
These properties tested on a lot-to-lot basis. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Recommended Primer MED1-161
Note: Some bonding applications may require the use of a primer.
Packaging
2 Pint Kit (910 g)
2 Gallon Kit (7.28 kg)
10 Gallon Kit (36.4 kg)
2 Drum Kit (360 kg)
Warranty
12 Months
Product Profile
Material Safety Data Sheet EU EN
For Use With Foam Medical Implants:
Biomaterials
Medical Silicones for Healthcare
Tubing
Food, Medical & Industrial Quality Silicone Tubing
Semco
Semco Products PDF Catalogue
SpeedMixers™
Laboratory Vacuum Mixer System
Biomaterials
Tubing
Semco
SpeedMixers™