Typical Properties | Average Result |
Uncured: | |
Appearance | Translucent |
Extrusion Rate†, Part A | 200 g/min |
Extrusion Rate†, Part B | 260 g/min |
Work Time | >72 hours |
Cured: 5 minutes at 165°C (329°F) in heat press. Stabilize for 3 hours minimum at ambient temperature and humidity. | |
Specific Gravity | 1.15 |
Durometer, Type A | 55 |
Tensile Strength | 1,100 psi (7.6 MPa) |
Elongation | 475% |
Tear Strength | 240 ppi (42.3 kN/m) |
Mass of Effluent | 1% |
Tissue Culture (Cytotoxicity Testing) | Pass |
Elemental Analysis of Trace Metals | Pass |
Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
†(Performed using a SEMCO® 440 nozzle with a ⅛" orifice and 90 ±5 psi air pressure)
Recommended Primer MED1-161
Note: Some bonding applications may require the use of a primer.
Packaging
50 mL Side-by-Side Kit
2 Pint Kit (910 g)
2 Gallon Kit (7.28 kg)
10 Gallon Kit (36.4 kg)
2 Drum Kit (360 kg)
Warranty
12 Months