Two-part, translucent silicone system designed for use with injection molding equipment
Self-lubricating
Cures with heat via addition-cure chemistry
1:1 Mix Ratio (Part A: Part B)
APPLICATION
For the injection molding of parts requiring a material with a high durometer including: molded rubber stoppers, gaskets, seals, valves, o-rings and other precision parts
Suitable for over-molding applications
Can be used with NuSil's Healthcare color masterbatches for applications requiring colored silicones
PROPERTIES
Typical Properties
Average Result
Uncured:
Appearance
Translucent
Work Time
>72 hours
Cured: 5 minutes at 165°C (329°F). Stabilize for 3 hours minimum at ambient temperature and humidity.
Specific Gravity
1.14
Durometer, Type A
55
Tensile Strength
1,165 psi (8.0 MPa)
Elongation
490%
Tear Strength
250 ppi (44.1 kN/m)
Tissue Culture (Cytotoxicity Testing)
Pass
Elemental Analysis of Trace Metals
Pass
Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Product Profile
