Polymer Systems
Technology Limited

Life Science

Premium Care:


Platinum Cure

Fast Cure Low Consistency Silicone Elastomer

  • A two-part, translucent silicone elastomer system
  • Cures rapidly at room temperature. Cure rate may be accelerated with heat.
  • Platinum addition cure
  • 1:1 Mix Ratio (Part A: Part B)
  • For use in potting, encapsulating, coating, and injection or transfer molding applications.
Additional information for Fast-Cure Silicones for Short-Term Implants: Fast-Cure Silicones for Short-Term Implants PDF Healthcare PDF tear sheet
Typical PropertiesAverage Result
Viscosity, Part A84,000 cP (84,000 mPas)
Viscosity, Part B65,000 cP (65,000 mPas)
Work Time15 minutes
Cured: 30 minutes at 150°C (302°F)
Specific Gravity 1.11
Durometer, Type A 25
Tensile Strength1,100 psi (7.6 MPa)
Elongation 624%
Tear Strength 74 ppi (13.5 kN/m)
Tissue Culture (Cytotoxicity Testing)Pass
Elemental Analysis of Trace MetalsPass

Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.

Recommended Primer MED1-161

Note: Some bonding applications may require the use of a primer.


50 mL Side-by-Side Kit
400 mL Side-by-Side Kit
2 Pint Kit (910 g)
2 Gallon Kit (7.28 kg)
10 Gallon Kit (36.4 kg)


12 Months

Product Profile - Full Details Product Profile
Safety Data Sheet Material Safety Data Sheet


Medical Silicones
Biomaterials - Medical Silicones for Healthcare

Advanced Technologies

Advanced Technologies Industrial & Engineering Silicones
Space - Aviation Grade Industrial & Engineering Silicones


Food Medical Industrial Grade Silicone Tubing
Food, Medical & Industrial Quality Silicone Tubing


Silicone Mixing Dispensing Degassing Equipment
Mixing Dispensing & Degassing Equipment for Silicone