Polymer Systems
Technology Limited

Advanced Engineering

Defence:
Commercial Aviation:
Optoelectronics:
Electronics:

CF1-3510

Potting and Encapsulating Elastomers

Fluorosilicone Potting and Encapsulating Elastomer

DESCRIPTION

Two Part, red, 10:1 Mix Ratio (Part A:B)
100 mole % flourosilicone
Cures with heat via addition-cure chemistry

APPLICATION

For applications requiring solvent resistance
Designed for protection of electrical components and
assemblies against shock, vibration, moisture, dust, chemicals,
and other environmental hazards
For molding parts such as O-rings, stoppers, and seals

PROPERTIES
Typical Properties	Result	Metric Conv.
Uncured:
Appearance, Part A	Red	-
Appearance, Part B	White	-
Viscosity, Part A	70,000 cP	70,000 mPas
Consistency, Part B	Thin Paste	-
Work Time	4 hours	-
Cured: 30 min at 150°C (302°F)
Specific Gravity	1.44	-
Durometer, Type A	20	-
Tensile Strength	210 psi	1.45 MPa
Elongation	135%	-

Recommended Primers CF2-135 or SP-120

Note: Some bonding applications may require the use of a primer.
CF2-135 is recommended for most metallic substrates, some plastics and when cure inhibition is observed on substrate.
In general, SP-120 is recommended for use with 100% Fluorosilicones.

Packaging

3 Ounce Kit
1 Pint Kit (555 g)
1 Gal Kit (4.44 kg)
5 Gal Kit (22.64 kg)

Warranty

12 Months