Typical Properties | Average Result |
Uncured: | |
Appearance* | Tan |
Work Time* | 3.5 hours |
Cured: 10 days minimum at ambient temp. and humidity | |
Appearance* | Tan, elastomer |
Specific Gravity* | 3.86 |
Durometer, Type A* | 80 |
Tensile Strength* | 425 psi (2.9 MPa) |
Elongation* | 80% |
Tear Strength* | 60 ppi (10.6 kN/m) |
Lap Shear Strength (primed w/ SP-120)* | 350 psi (2.4 MPa) |
Young's Modulus | 950 psi (6.6 MPa) |
Volume Resistivity* | 0.007 ohm cm |
Thermal Conductivity | 1.00 W/(mK)(24 x 10-4 cal/(cm sec°C)) |
Coefficient of Linear Thermal Expansion | |
Below Tg (-150°C to -115°C) | 45 ppm/°C (45µm/m/°C) |
Above Tg (-95°C to 250°C) | 185 ppm/°C (185µm/m/°C) |
Dynamic Mechanical Analysis (DMA) | See Profile PDF for Graph |
Collected Volatile Condensable Material (CVCM)* | 0.02% |
Total Mass Loss (TML)* | 0.25% |
*Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.
Packaging
50 Gram Kit
100 Gram Kit
250 Gram Kit
500 Gram Kit
Warranty
6 Months