Polymer Systems
Technology Limited

Advanced Engineering

Optoelectronics:
Electronics:

EPM-2462

Adhesives/Sealants,Electrically Conductive/Static Dissipative

Low Volatility Electrically Conductive Silicone Elastomer

DESCRIPTION
  • Two-part, tan-colored, electrically conductive silicone
  • 20:1 Mix Ratio (Part A: Part B)
APPLICATION
  • For applications requiring low volatility
  • Well suited for form-in-place conductive gaskets
  • Use as a thermally or electrically conductive interface material
PROPERTIES
Typical PropertiesAverage Result
Uncured:
Appearance*Tan, paste
Work Time*2.75 hours
Cured: 30 minutes at 150°C (302°F)
Specific Gravity*3.39
Durometer, Type A*85
Tensile Strength*525 psi (3.6 MPa)
Volume Resistivity*0.005 ohm cm
Thermal Conductivity1.20 W/(mK)(29 x 10-4 cal/(cm sec°C))
Coefficient of Linear Thermal Expansion
Below Tg (-100°C to -50°C)140 ppm/°C (140µm/m/°C)
Above Tg (-30°C to 250°C)215 ppm/°C (215µm/m/°C)
Volatile Content (1 hour at 275°C)0.2%
Ionic Content, Cl<5 ppm
Ionic Content, K<7 ppm
Ionic Content, Na<5 ppm

*Properties tested on a lot-to-lot basis. Do not use the properties shown in this technical profile as a basis for preparing specifications. Please contact NuSil Technology for assistance and recommendations in establishing particular specifications.

Recommended Primer CF1-135

Note: Some bonding applications may require the use of a primer.

Packaging

50 Gram Kit
100 Gram Kit
500 Gram Kit

Warranty

12 Months

Product Profile - Full Details Product Profile
Material Safety Data Sheet EU EN Material Safety Data Sheet

Biomaterials

Medical Silicones
Biomaterials - Medical Silicones for Healthcare

Advanced Technologies

Advanced Technologies Industrial & Engineering Silicones
Space - Aviation Grade Industrial & Engineering Silicones

Tubing

Food Medical Industrial Grade Silicone Tubing
Food, Medical & Industrial Quality Silicone Tubing

Equipment

Silicone Mixing Dispensing Degassing Equipment
Mixing Dispensing & Degassing Equipment for Silicone